Your Z-Offset is burned into the memory of the printer from the factory. If significant maintenance or a replacement extruder has been made you may be required to modify the Z-Offset.
From MatterControl 1.7 onwards you have the ability to change the Z-Offset while printing using a process called "babystepping". Babystepping adjusts the software Z-Offset and the values are added or subtracted from the firmware offset. Typically the offset may be changed by up to 0.3mm to get optimium results, this is especially helpful when setting up a new printer. Check out our article that explains how to use babystepping and how to the adjust the offset burned into the firmware.
Didn't find what you what you were looking for? Try using our Troubleshooting Tool!